Using a block of wood as a ruler mark the ends for cutting.
Roof ledger board installation.
Add the aluminum flashing tuck the aluminum flashing underneath the bending and siding over the ledger.
View how to measure your patio cover.
The ledger should be attached before the foundation is built for a deck patio roof posts and other structure.
To cut sloping rafters for a house attached patio roof lay a rafter board so it rests on its edge on both the ledger and the beam parallel to the ledger.
These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
Flash and bolt the ledger board in place to the house wall.
The wall leg is at least 7 in.
You have to do it thoroughly so that the rafters sit flush on it.
Locating and mounting the ledger is normally a fairly easy process.
Make a cutting on one of the sides of the horizontal roof beam on an angle.
This may seem excessively tall but is needed in order for the water resistive barrier wrb and siding to overlap the top.
Use a speed square to mark and cut your rafter angle to the roof pitch.
View patio kit prices.
View how to install roof top ledger board video.
A house attached patio roof takes advantage of the house s structure by supporting one end of the roof on a ledger mounted horizontally to the house.
The deck boards have been depicted with a gap between the first board and the house only to emphasize flashing overlapping the ledger.
View how to measure.
The rafter pitch angle.
Put down ledger board s face.
The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.
Attach the horizontal beam by using a nail gun.
On site the first board would be positioned within 1 2 from the wall flashing.
Do not attach the header directly to a house cantilever.
Then force the rafter s tip snugly against the house wall.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
Call us at 800 531 5994.
After the ledger is installed a second strip of membrane tape is applied over the top of the ledger and about 1 2 in.
After that to make it flush with the roof of the existing house cut the two outer rafters.
Get a free quote.